FREQUENTLY ASKED QUESTIONS

The Bulb Grabber will work with all standard base bulbs ranging from 1 ¾” to 5” including CFL’s.

Dual action means you can open the fingers to grab a bulb from the top and bottom end of the device.

The Bulb Grabber has a 3-part extension and expands up to 11 feet.

Yes, the Bulb Grabber is primarily made of plastic and non-conductive. However, we always recommend turning off power or circuits to avoid any potential issues.

In order for the Bulb Grabber to have the required grip force to hold and turn bulbs the tension created by the internal mechanism is necessary to be set to this level. We recommend setting the device on the floor when pulling down on the upper mechanism which creates additional leverage and makes it easier to operate when loading and unloading bulbs.

Yes the Bulb Grabber can be used both indoors and outdoors.

We do make a broken bulb extractor and that can be purchased separately via our website.

The housing of the Bulb Grabber is primarily made of plastic and steel tubes.

The mechanism that opens and closes the fingers will make some sound when the fingers are expanded and contracted and also when the pole is extended or contracted. This is a normal operating sound and nothing to worry about.

As long as the physical light bulbs are accessible from the ground and you have enough room based on the angle of the bulbs to access them you should be able to use the Bulb Grabber to remove and replace light bulbs in your ceiling fan.